Auto-cut how to install

First and foremost, make sure to disconnect the table saw's power. and must remove the Riving Knife(why? to see in Q&A).

1. Connect the two main shafts, install the shaft's tail plugs and washers, and then thread the rods through the tail and control box.

2. Power up the control box and activate the electromagnetic.

3. Mount the main unit onto the end of the shafts using the tail plugs and washers.

4. Press down on the main unit to make the wheels contact the tabletop. Then, turn the large black knob clockwise to lock, switch off the electromagnetic.

5. Adjust the fence's position; adjust the overall system position to ensure that both wheels are parallel to the fence.

6. Turn on the laser and raise the saw blade.

7. Adjust the overall system position by moving it forward or backward until the laser head points directly at the saw blade's highest point.

8. Press the electromagnetic switch to start and secure the control box again.

9. Move the tail support piece along the axis to the left until it reaches the edge of the tabletop. Use two long bolt inserts to find the correct positions for the two tail support pieces.

10. Use four set screws to fasten the tail support pieces securely.

11. Tighten the bolt inserts and apply slight pressure to ensure that the bottom plate of the tail support piece is in complete contact with the tabletop. Then, lock the two adjustable handle bolts.

12. Secure the power supply with cable ties to complete the installation.